Valcom V-1020C Installation Manual

8" ceiling speaker

Hide thumbs Also See for V-1020C:

Table of Contents

Table of Contents

Page 2 Required tools for installation of a V-1020C speaker with V-9914 bridge.
Page 3 First, cut a pre-measured hole in the ceiling tile.
Page 4 Using the bridge as a guide, determine the screw holes for the ceiling tile.
Page 5 Align the speaker with the holes in the ceiling tile.
Page 6 Align the speaker with the bridge on either side of the ceiling tile.
Page 7 Attach all three pieces with the provided hardware.
Page 8 Connect all wiring to the screw cages on the speaker.
Page 9 Place the speaker assembly in the ceiling grid.
Page 10 Lower the speaker assembly into position in the ceiling grid.
Page 11 Insert the included volume control knob and adjust the speaker volume...
Page 12 ...or adjust the speaker volume with a flat blade screwdriver.