MaxTech PCI Internal Voice/FAX/Data/Speakerphone Modem User Manual page 13

%E1 V.22bis auto-retrain enabled
%E2 Enable line signal quality monitor and
%G_ %G0 Enable Auto Fall Forward/Back
%G1 Disable Auto Fall Forward/Back
-C_ -C0
-C1
-C2
3.5 MNP/V.42/V.42bis Commands
%A n
%C_ %C0 Disable MNP Class 5 data compression
%C1 Enable
\A_ \A0
\A1
\A2
\A3
\B n
\C_ \C0
\C1
\C2
\G_ \G0
\G1
\J_ \J0
\J1
\K n
fallback/fallforward
Calling tone disabled
1300hz calling tone
V.8 and 1300hz calling tones enabled
Set auto-reliable fallback character to n
(where n = 0 to 127, ASCII). Requires the
\C2 setting. Default=13
compression
64-character maximum MNP block size
128-character maximum MNP block size
192-character maximum MNP block size
256-character maximum MNP block
size
Send a 1/10 second line break to the
modem, where n = 1 to 9. At normal
connect, the default is 0
Do not buffer data during LAPM/
MNP handshaking
Buffer all data for 4 seconds, until
receiving 200 characters or until a packet
is detected
Do not buffer data; switch to normal
mode when fallback character is
detected
Disable DCE flow control
Enable DCE flow control
Disable serial port data rate
adjustment (keep high data rate
between
regardless of modem-to-modem
data rate)
Enable serial port data rate adjustment
so serial data rate automatically adjusts
to match the modem-to-modem data rate
Set break control, where n= 0 to 5.
11
MNP Class
DTE and
5 data
modem,