Advertisement
ADDITIONAL INFORMATION
FOR DUAL-VOLTAGE DRYERS
For use in North America, the voltage selector
switch should be placed in the 125 position. For
use in several countries overseas, the voltage
selector may need to be placed in the 250 posi-
tion. Confirm the voltage available at each over-
seas location before using the appliance. For con-
nection to a 240-volt supply, use an attachment
plug adapter of the proper configuration for the
power supply.
For 110-125 Volt Operation
Flick the dual voltage switch to the 125
position. In this position, the dryer has two
settings. It provides two speeds and two
heats—low speed and low heat on LO and
high speed and high heat on HI.
For 220-250 Volt Operation
First put the HI-LO switch into LO. Flick the Dual
voltage switch to the 250 position. At 220-250V
while set at LO, the dryer operates only at high
speed with high heat. Do not attempt to operate
the HI-LO switch or change to 125 when oper-
ating on 220-250V. The switches must be set
and remain in the LO and 250 positions. A plug
adapter may be necessary in certain countries.
USER
MAINTENANCE
Your dryer is virtually maintenance free. No lubri-
cation is needed. For proper operating perfor-
mance, the dryer must be kept clean. When
cleaning is needed, unplug the cord, and clean
dust and lint from air intake openings with a
small brush or the brush attachment of a vacuum
cleaner. The outer surface of the dryer should be
wiped clean with a damp cloth only.
Blocked or clogged air intake vents will cause
the dryer to overheat.
If overheating occurs, an automatic safety device
will shut the dryer or the heat off to prevent dam-
age or personal injury. If the unit or the heat
cycles off, unplug the cord and allow the dryer to
cool for 10 to 15 minutes before restarting. Make
sure the air vents are clean.
Advertisement
