Table of Contents
Advertisement
Before starting
Before starting the saw, check that:
•
The incoming electrical cable has been connected to a
fuse rated at least 16 A.
•
The power lead is connected to the saw unit.
•
The 32 A, 25 A or 16 A power setting is chosen.
•
All controls on the remote control have been set to zero
position. If this is not done, a message in the display will
prompt this when the start button is pushed.
•
Enclose the area to be cut so that unauthorised persons
can not be injured or disturb the operator.
IMPORTANT! A higher speed than the recommended
speed can result in personal injury and damage to the
equipment.
Starting
•
Check that the emergency stop button on the power unit
and the stop button on the remote control are not pressed
by turning the them clockwise.
STARTING AND STOPPING
•
Turn the main switch to "1"-position.
ON
•
The power unit is activated and this is shown by the
indicator light shining.
The water valve in the power unit is now closed. This valve
opens again when the blade rotation is started.
•
The remote control display shows "SELECT FUSE".
If the available fuse is 32 A, confirm this by pressing the
membrane key marked OK".
•
If no 32 A fuse is available, you can select 25 or 16 A
instead by pushing the arrow down. The display now
shows "SELECT FUSE" 25 A or 16 A.
With a 25 A fuse you can use approx. 70% of the full
output. With 16 A you can use approx. 50% of full output.
The function is intended to obtain as high output as
possible without overloading the fuse.
The power output in percent is shown on the display
during sawing.
•
Press OK to confirm the selection.
•
The display now shows "Husqvarna PP-440 HF PRESS
START".
– 11
English
Advertisement
Table of Contents
