Intel NetStructure DM/V600-4E1-cPCI Quick Install Card

Intel    NetStructure™
DM/V600-4E1-cPCI
Quick Install Card for CompactPCI
Part Number 05-1969-001
Copyright © 2003 Intel Corporation

Before You Begin

Electrostatic Discharge
CAUTION: All computer boards are electrostatic
sensitive. Handle all static sensitive components,
boards and computers at a static-safe work area.
To prevent damage caused by static electricity:
•
Wear a grounded, static-dissipative wrist strap for
the entire hardware installation.
•
Work at a static-safeguarded work area.
A Static-Safe Work Area
Static-Dissipative
Mat
Static-Dissipative
Wrist Strap
Common
Ground
Point
Installing the Product
CAUTION: The procedures provided in this document
fully describe how to install the DM/V600-4E1-cPCI in a
"cold" system (powered off). The procedure for live
insertion, or hot swap, is system dependent. Refer to
the Administration Guide for your particular Intel®
system software release for further details.
Physical Description
7
6
5
4
3
2
1
Compact PCI Baseboard
1. Out of Service LED—Indicates board is out of service or in
reset from host
2. Alarm Status LEDs:
RED—Indicates loss of clock on incoming lines from external
networks
YELLOW—Indicates loss of frame synchronization at far end
external networks
Carrier Signal—Indicates board is powered up and receiving
signal from external E–1 sources
Loopback—Indicates the E–1 networks are in loopback mode
3. Power LED—Indicates board is powered up
4. Board Extractor
5. Global Memory Module
6.
J5—Signal Processor Daughterboard connector
7. Signal Processor Daughterboard
8.
P1, P4, and P5—Compact PCI board connectors to backplane
8
12
11
8
10
E–1 120-Ohm E–1 75-Ohm
Rear I/O Modules
9. BNC Connectors—Connectors to external E–1
(75-Ohm) telephone network interface
10. P2—Network interface test port
11. J1, J2, J3, and J4—Connectors to external E–1
(120-Ohm) digital telephone network interface
12. Ethernet Connectors*—Connects to Ethernet network
13.
P5—Rear I/O module connector to CompactPCI
backplane
* The connection to the Ethernet is used only for
voice-over IP (VOIP) applications. In all other instances,
it is not functional.
13
9
9