Advertisement
While charging the DC-11 device,
you can use it to charge the battery
in one or two devices. Connect the
Charge the battery of the other device
You can use the DC-11 device to
charge the battery in two devices at
the same time.
The fully charged DC-11 device has
enough power to fully charge a 950
mAh battery once.
1. If the charger plug you want to
use is inserted into the end of the
DC-11 device, pull the plug out
from the recess, and uncoil the
charging cable from the side of
the device.
2. Connect the charger plug to the
other device.
3. Press the power key of the DC-11
device.
4
Copyright © 2010 Nokia. All rights reserved.
device or devices to the DC-11
device.
The indicator light flashes during
charging. If the light does not
flash, check that the other device
is properly connected to the DC-
11 device. If the light is not
displayed, charge the DC-11
device, and press the power key
to switch it on.
If the DC-11 device cannot start
charging the other device within
about 30 seconds, the DC-11
device switches off.
4. Check the charge level from the
connected device.
5. When the battery in the other
device becomes fully charged,
the indicator light stops flashing
Advertisement
