Advertisement
micro-USB charger plug (4), and
2.0 mm charger plug (5).
Before you can use the DC-11 device
to charge the battery in a
compatible device, you must charge
the DC-11 device.
Charge the DC-11 device
Before charging the DC-11 device,
carefully read
"Battery and charger
information".
Warning: Use only
chargers approved by
Nokia for use with this
particular model. The use of
any other types may
invalidate any approval or
warranty, and may be
dangerous.
When you disconnect the power cord
of any accessory, grasp and pull the
plug, not the cord.
1. Connect a compatible charger to
a power source.
Copyright © 2010 Nokia. All rights reserved.
2. Connect the charger cable to the
charger connector on the DC-11
device. The device switches on.
The indicator light flashes during
charging. If the light is not
displayed, check that the charger
is properly connected to the DC-
11 device.
3. When the DC-11 device is fully
charged, the indicator light stops
flashing. Disconnect the charger
from the DC-11 device, then
from the power source.
The DC-11 device can also be
charged through a USB port of a
compatible PC using the Nokia
connectivity cable CA-100 or CA-
126 (sold separately). Connect one
end of the cable to the charger
connector on the DC-11 device and
the other end to a USB port on the
PC.
3
Advertisement
