Page 1
TOBA F3B-F3F Instruction Manual Unpacking Please unpack the plane carefully making sure that you have retrieved all • of the small parts. Don’t throw the box out until you are 100% sure it’s empty! • Check that all the parts are supplied.
Page 2
TOBA F3B/F3F parts Before construction Start with a clean workbench and cover it with some foam, or a soft thick • cloth to protect the finish of the wings and fuselage as you work. Be careful not to place the wings or fuselage on any screws or tools etc •...
Page 3
Wings Control horns for ailerons Make up control rods and clevises using the parts supplied. • The flap rods and the ailerons should be about 63 mm • including clevis length - but check before you cut! Control horns for flaps Zero the servos by using your R/C unit.
Page 4
When the wiring harness is positioned inside the wing and accessible, • servos can be installed. First, check the position of the servos to make sure they are all • symmetrical (In the same place) in each wing. Install the control rods on to the servos and check that they do not bind, •...
Page 5
Fuselaje Hook 92 mm from leading edge www.modellmarkt24.ch www.modellmarkt24.ch...
Page 6
100-105 mm from leading edge www.modellmarkt24.ch www.modellmarkt24.ch...
Need help?
Do you have a question about the TOBA F3B and is the answer not in the manual?
Questions and answers