Safety Information - Vax Mach3 U90-M3 series Instruction Manual

Bagless upright
Hide thumbs Also See for Mach3 U90-M3 series:
Table of Contents

Advertisement

U90-M3 & M4 Series User Guide v1.4.qxd:UG

2. Safety Information

For Household Use Only
When using the vacuum cleaner, basic safety precautions
should always be observed, including the following:
1.
Only use the vacuum cleaner indoors on dry surfaces.
Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
2.
Turn off the vacuum cleaner controls before
disconnecting or connecting from the mains supply.
3.
Always unplug the vacuum cleaner before
connecting or disconnecting the hose and
accessories.
4.
Children should be supervised to ensure that they do
not play with the appliance.
5.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
6.
Use only as described in this manual. Use only Vax
recommended attachments.
7.
Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord is damaged,
it must be replaced by the manufacturer or a
recommended Service Agent to avoid hazard and
invalidating the guarantee.
8.
Do not pull or carry by cord/hose. Do not use the
cord/hose as a handle, close a door on the cord/hose
or pull cord/hose around sharp edges or corners. Do
not run the vacuum cleaner over the cord/hose. Keep
the cord away from heated surfaces.
9.
Do not put any objects into openings. Do not use
with any openings blocked and do not restrict
airflow. Keep all openings free of dust, lint, hair or
anything that might reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.
12. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene etc.) or use in the
presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material (chlorine,
bleach, ammonia, drain cleaner etc.).
14. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
15/7/10
15:36
Page 3
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
15. Do not use without ALL of the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner in a cool, dry area.
19. Turn off the on/off switch before unplugging the
vacuum cleaner
20. Use only CE-approved 13 amp extension cords. Non-
approved cords may overheat. Care should be taken
to arrange the cord so that the cord cannot be
tripped over.
WARNING: Always switch off and unplug the
!
vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.
CAUTION: The vacuum cleaner is a very
!
powerful unit. Before plugging the cord into
the electrical outlet, make sure the switch is in the
'off' position. Hold the vacuum cleaner firmly when
starting and in use.
IMPORTANT: If the inlet, hose or extension
!
tube is blocked, switch off the vacuum cleaner
and remove the blockage(s) before re-starting the
vacuum cleaner.
IMPORTANT: Cleaning filters regularly
!
maintains vacuum performance. Make sure all
filters are replaced back into the vacuum cleaner
before using.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
Motor Thermostat
IMPORTANT:
The motor is equipped with a
!
thermal cut-out. If for any reason, the
vacuum cleaner should over-heat, the thermostat
will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the
electrical outlet and turn off the switch. Remove
the dirt container and empty. Clean the filters.
Allow the cleaner to cool for approximately one
(1) hour. To re-start, plug into an electrical outlet
and switch back on.
3
safety information

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mach4 u90-m4 seriesU90-m3 seriesU90-m4 series

Table of Contents