Remote Control Batteries - Panasonic TH-50LFC70U Operating Instructions Manual

Remote Control Batteries

Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Display set.
6. Do not burn or breakup batteries.
7. Batteries must not be exposed to excessive heat such as sunshine, ¿ re or the like.
How to use the Ferrite core
PC with DVI-D
video out
Installing the Ferrite core
1.
Pull back the tabs
(in two places)
2. Insert batteries - note correct
polarity (+ and -).
Stereo mini plug (M3)
Less than
Ferrite core
1.97 inch (5 cm)
(supplied)
DVI-video cable (Within 5 m)
2.
Open the
Ferrite core
"R6 (UM3)" size
-
+
+
-
Less than
1.97 inch (5 cm)
3.
Route the
cable through
and close
Accessories
3. Replace the cover.
Shared with PC IN.
4.
Fix the Ferrite
core with the
cable tie
9