Table of Contents
Advertisement
7. According to the operating
system, you can change
the default device to output
the sound with the following
methods:
- XP: Change the default
sound playback device
to [AK500N USB DAC]
from 'Control Panel> Sounds and Audio Device'.
- 7/8: Select [AK500N USB DAC] from 'Control
Panel>Sound>Playback' tab, and select [Set as
Default Device] on the bottom.
You need to complete this step, only if you are using AK500N with USB DAC for the first time.
You do not need a separate follow-up to select AK500N for the sound output.
If you connect to USB DAC when paying PCM or Native DSD, the music being played will be stopped automatically.
If you press [Connect to a Media device] on the screen when it is connected to the USB DAC, the USB DAC will be
disconnected, and reconnect to MTP mode again.
If you reboot AK500n after the connection to the USB DAC, it will be changed MTP mode again.
For high sound quality, it is recommended to change the default format to
[24bit, 192000Hz(Studio quality)] on the advanced tab, after clicking the 'Properties'
button of [AK500N USB DAC] from Panel>Sound in Windows 7/8.
- MAC OS X: Select the
Output tab from the sound
menu under the System
Preferences, and select
[AK500N USB DAC].
5 0
Using the Device
Advertisement
Table of Contents
