Advertisement
GETTING TO KNOW THE
HOT GEL/LATHER MACHINE
12
3
2
1
13
9
1) Gel nozzle
2) Gel release button
3) Adjustment switch
4) Power "OFF" button
5) Ready indicator light
6) Power "ON" button
7) Variable temperature control
8) Locking tab
9) Lather nozzle
10) Protective cylinder
11) 120v power cord
12) Top of machine: press down here to
dispense lather or press down here
and slide (3) adjustment switch to press
down and lock for gel use.
13) Cap removal key (stored at the bottom
of the protective cylinder)
5 SIMPLE STEPS TO A GREAT
HOT SHAVE
VERY IMPORTANT SET-UP INSTRUCTIONS
7
4
5
6
STEP 1
11
8
10
- Attach proper nozzle, lather or
- Be sure the "adjustment
Caution: always use the gel nozzle for gel and
lather nozzle for lather
STEP 2
- Use " cap removal tool" found
adjustment
switch
gel, by twisting into place
switch"is in the "lather" postion
for lather or gel set-up
in the bottom of base to remove
plastic cap on can
STEP 3
locking tab
can valve
- Turn unit upside down, as shown
- Depress "locking tab"
- Carefully line up lather or gel
valve with center seal
- Gently insert can valve into seal
and release "locking tab"
- Press can until it locks in place
*IMPORTANT NOTE:
If can valve is not properly
inserted into center seal, gel will leak out of unit.
STEP 4
control cap
To use with gel:
- Depress black "control cap" firmly
and slide the "adjustment switch "
as far as possible towards the gel
side. This step holds the "control
cap" down in the gel position
To use with lather:
- Move adjustment switch into lather
position
NOTE:
Slide adjustment switch as far as possible, it
may not be all the way to the gel position
centre
seal
adjustable
switch
Advertisement
