Whirlpool WSZ57L18DM User Manual page 6

Handle
A
A. Grommet
B. Handle
C. Setscrews
Freezer Leveling and Door Closing
Your freezer has 2 front adjustable legs — one on each side. The back
of the freezer rests on 2 fixed rollers. The base grille covers
the adjustable brake feet and roller assemblies located at the bottom
of the freezer below the freezer door. Before making any adjustments,
remove the base grille and move the freezer to its final location.
Tools Needed: ¹⁄₄" hex driver, Phillips head screwdriver
1. Remove the base grille screws. Grasp the grille firmly and pull it
toward you. Open the freezer door to access the brake feet.
NOTE: To allow the freezer to roll more easily, raise the brake feet
by turning them counterclockwise. The front rollers will be touching
the floor.
2. Move the freezer to its final location.
3. Lower the brake feet, by turning them clockwise, until the rollers
are off the floor and both brake feet are snug against the floor. This
This keeps the freezer from rolling forward when opening the
freezer door.
Door Removal and Replacement
B
C
IMPORTANT: If you need to make further adjustments involving the
brake feet, you must turn both brake feet the same amount to keep
the freezer level.
4. Make sure the door closes easily. If you are satisfied with the door
opening and closing, skip the next section. If, however, the door
does not close easily or the door pops open, adjust the tilt.
To Adjust the Cabinet Tilt:
NOTE: Having someone push against the top of the freezer takes some
weight off the brake feet. This makes it easier to turn them.
Open the freezer door. Use a ¹⁄₄" hex driver to turn both brake feet
clockwise the same amount. This will raise the front of the freezer. It
may take several turns to allow the door to close more easily.
6
Top Hinge
A
B
B
C
A. Top Hinge Cover
B. / " Hex-Head Hinge Screws
5
16
C. Top Hinge
Bottom Hinge
B
A. Hinge Pin
B. / " Hex-Head Hinge Screws
3
8
¹⁄₄"
A
B
A. Brake foot
B. Front roller
A