Firmware Handling - Panasonic PAN1311/21 USB Quick Start Manual

Quick Start Guide
Evaluation Board (EVB) PAN1311/21 USB

5.3 FIRMWARE HANDLING

At the testing tab firmware can be downloaded (Download image) to the EVB and a number
of changes can be made to it (Change BD-data) like assigning a unique BT address (e.g.
0003199E8B73) and oscillator trim value. Make sure that the Production mode is enabled
before any of these buttons on this tab are used. To do this mark On and confirm with a click
on Production mode. The text field should inform you about of success of this procedure. Be
advised to do a hardware reset (push button on EVB) after all changes were made.
Please note:
The BD_Address and OSC_Trim value have to be read out by "Read BD Address" command
before downloading. They have to be programmed by "Change BD-data" command after
writing the new image.
PANASONIC ELECTRONIC DEVICES EUROPE
Figure 6 : Testing tab
GmbH
No.
DS-PAN1311/21USB
PAGE
6 of 11
DATE
15.09.2011
DESIGNED
REV.
1.1
Erstellt
IW