Piper Cherokee Arrow II Pilots Operating Manual page 76

ARROW
NOTE
For precise tracking over OMNI station, without "S" turn,
position coupler mode selector to HDG mode just prior to
station passage. If holding pattern is desired, position coupler
mode selector to HDG mode at station passage inbound and
select outbound heading in direction of turn. After elapsed time,
dial inbound course on Course Selector D.G. When aircraft
heading is 45" to radial, position coupler mode selector to OMNI
mode.
(6) LOC Approach Only
(a) To intercept dial ILS outbound course on Course Selector
D.G. When stabilized, position coupler mode selector to
LOC
REV
mode.
(b) After interception and when beyond outer marker, position
coupler mode selector to HDG mode and dial outbound
procedure turn heading. After one minute, dial inbound
procedure turn heading in direction of turn.
(c) When aircraft heading is 45" to ILS inbound course dial
inbound course on Course Selector D.G. and position
coupler mode selector to LOC NORM mode.
(d) At the missed approach point (M.A.P.), or when missed
approach is elected, position coupler mode selector to HDG
mode and execute missed approach procedure.
(7) LOC Approach
-
Back Course (Reverse)
(a) To intercept dial ILS Back Course outbound heading on
Course Selector D.G. When s t a b i l ~ ~ e d , position coupler
mode selector to LOC NORM mode.
(b) After interception and when beyond fix, position coupler
mode selector to HDG and dial outbound procedure turn
heading. After one minute, dial inbound procedure turn
heading in direction of turn.
(c) When heading
45"
to inbound course, dial inbound course
on Course Selector D.G. and position coupler mode selector
to LOC
REV
mode.
(d) Approximately 112 mile from runway, position coupler
mode selector to HDG mode to prevent "S" turn over ILS
station near runway threshold.
(e) Missed approach
-
same as Front Course. (See (6) d)
FAA APPROVED JUNE 18,1974 REPORT:
VB-560 PAGE 3-23
MODEL: PA-28R-200