ZyXEL Communications ZyWALL 5 Support Notes page 35

Key Settings:
Check the box to enable BWM on the interface. Note that if you would like to manage
Active traffic from WAN to LAN, you should apply BWM on LAN interface. If you would like
to management traffic from WAN to DMZ, please apply BWM on DMZ interface.
Enter the total speed to manage on this interface. This value is the budget of the class
Speed
tree's root.
Choose the principle to allocate bandwidth on this interface. Priority-Based allocates
Scheduler
bandwidth via priority. Fairness-Based allocates bandwidth by ratio.
Check this box if you would like to give residuary bandwidth from Interface to the
classes who need more bandwidth than configured amount. Do not select this if you
Maximize
want to reserve bandwidth for traffic that does not match a bandwidth class or you want
Bandwidth
to limit the bandwidth of each class at the configured value. (Please note that to meat the
Usage
second condition, you should also disable bandwidth borrowing on the class.)
Go to ADVANCED->BW MGMT->Class Setup, select the interface on which you would like to setup
the Class tree.
Click the radio button besides the Root Class, then press 'Add Sub-Class'
All contents copyright (c) 2006 ZyXEL Communications Corporation.
ZyWALL 5 Support Notes
35