Troubleshooting; Safety Information - I-Tech Clip VR 302 User Manual

i.Tech Bluetooth headset is designed to work with Bluetooth devices. Due to large
variability between different Bluetooth devices from different manufacturers,
interoperability between the headset and all Bluetooth-enabled products is not
guaranteed.

Troubleshooting

I can hear crackling noise
To receive the best audio quality, it is recommended to wear your headset on the same side
of the body as your mobile phone.
I can't hear anything in my headset
• Ensure the headset is turned on and is properly charged.
• Ensure the headset is properly paired with the mobile phone.
• Make sure that the mobile phone is connected with the headset – if it does not connect,
either refer to the mobile phone's Bluetooth menu or by pressing the MFB once (see "Using
your Headset" and "Pairing Your Headset with a Bluetooth Mobile Phone").
I can't connect my headset with mobile phone
• Ensure your headset is turned off and is properly charged.
• Ensure the headset is properly paired with your mobile phone.
• Ensure your mobile phone's Bluetooth feature is activated. Please refer to your mobile
phone user guide for specific instruction.
• Ensure the headset is within ten metres range of your mobile phone and there are no
obstructions, such as walls or other electronic devices in between.
If the above steps do not solve your problem, please recharge the headset and remove your
mobile phone's battery for a while.
I can't turn off the headset or the headset does not response
• You may do a "hardware reset" on your headset if you can't turn it off or it doesn't
response.
• Plug the charging cable to the headset and then press and hold the volume key and MFB
button for 2 sec.
• Release the both buttons and the status indicator will stay red again and the headset is
reset.

Safety Information

• Check and observe local laws regarding the use of a mobile phone and a headset while
driving. If you use the headset while driving, ensure your full attention and focus. It is
your responsibility to drive safely. Consider to pull off the road before making or
answering a call.
• Never leave your headset above any air bag deployment area inside your car as serious
injury may result when an air bag deploys.
• Never allow children to play with the headset – small parts may be of choking hazard.
• Observe all signs and displays that require an electrical device or RF radio product to be
switched off in designated areas. These could include hospitals, blasting areas, and
potentially explosive atmospheres.
• Turn off your headset prior to boarding an aircraft. Do not use your headset inside an
aircraft.
• To prevent damage to your hearing, please do not set the listening volume too high.
• Do not attempt to modify the headset.
• Do not keep the headset near a wash basin or other wet places.
• Do not use the headset outdoors in the rain.
• Do not use the headset in stormy weather.
• Do not clean the headset while it is being charged. Always disconnect the charger from
the headset before cleaning.
• Do not attempt to force open the built-in battery.
• Only charge the headset's built-in battery in accordance with the instructions described in
this user guide.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
7 8