Pairing Your Headset With A Mobile Phone; Using Your Headset; Factory Reset - I-Tech Clip VR 302 User Manual

Talk & Standby Time
A fully charged battery can offer up to 6 hours of talk time and up to 120 hours of standby
time. The headset remains in standby mode after being turned on.
Pairing Your Headset with a Bluetooth Mobile Phone
1) Ensure the headset is off.
2) To activate the pairing mode, press and hold the headset's MFB for 8 seconds without
releasing your finger until its status indicator flashes blue and red light alternately.
3) Activate your mobile phone's Bluetooth, search Bluetooth devices, select "ClipVR 302"
and enter the passcode "0000". When the pairing is completed, the headset's status
indicator will flash blue light rapidly five times.
If the pairing cannot be completed within 3 minutes after the pairing mode has been
activated, the headset's status indicator will flash purple rapidly five times and then turns
to standby mode. Repeat steps 1 to 3 to pair both devices again.

Using your Headset

Function Button
POWER ON Press and hold the
MFB for 5 seconds
When you turn on your headset for the first time, the headset proceeds into pairing mode,
i.e. the status indicator flashes blue and red alternately, so that you can immediately pair it
with your mobile phone.
POWER OFF Press and hold the
MFB for 2 seconds
Answer a call Press the MFB once
Audio Status indictor
Short beep Flash blue light 3 times
Long beep Red light for two seconds and then
the light goes off
Flashing blue light and sounding
buzzer alternately
Using your Headset
Function Button
End a call Press the MFB once
Adjust Volume Press the Volume Key
once to increase/decrease
by 1 step (Total 6 levels)
Voice Dialing* Press the MFB once
Say the voice tag as soon as you hear the short beep and you must have recorded the
voice tag into your mobile phone.
Last no. Redial* Double click the MFB
Reject a call* Press and hold the
Volume Key for 2 seconds
Call Transfer While speaking, press and
(headset to hold the volume Key for 2
mobile phone)* seconds
Call Transfer hile speaking, press MFB
(mobile phone once
to headset)*

Factory Reset

You may reset the headset to its default settings. Resetting will also remove the pairing
history of your headset with the mobile phone.
1. Hold the volume key and the plug charging cable into the charging socket. The status
indicator will flash purple 3 times.
2. Release the volume key.
3. The status indicator will stay red again and the headset is reset.
5
Audio Status indictor
Flashing blue light
Flashing blue light
Short beep Flashing blue light
Flashing blue light
Short beep Flashing blue light
Flashing blue light
Flashing blue light
* Subject to mobile support
6