Dodge Charger SRT 2014 Owner's Manual page 270

268 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
to the change of state from Adaptive Cruise Control to
normal Cruise Control. "Cruise Ready" will be displayed
if the system was in ACC READY or ACC SET position.
"Cruise Off" will be displayed if the system was in the
ACC OFF position. To switch back to Adaptive Cruise
Control mode, press the MODE button a second time.
WARNING!
In the normal Cruise Control mode, the system will
not react to vehicles ahead. In addition, the proximity
warning does not activate and no alarm will sound
even if you are too close to the vehicle ahead since
neither the presence of the vehicle ahead nor the
vehicle-to vehicle distance is detected. Be sure to
maintain a safe distance between your vehicle and
the vehicle ahead. Always be aware which mode is
selected.
To Set A Desired Speed
When the vehicle reaches the speed desired, press the
SET - button and release. The EVIC will display the set
speed.
NOTE: You must observe the display when setting or
changing speed, not the speedometer.
To Vary The Speed Setting
To Increase Speed
When the Normal (Fixed Speed) Cruise Control is set,
you can increase speed by pushing the RES + button.
The speed increment shown is dependant on the speed of
U.S. (mph) or Metric (km/h) units:
U.S. Speed (mph)
• Pressing the RES + button once will result in a 1 mph
increase in set speed. Each subsequent tap of the
button results in an increase of 1 mph.