JVC DLA-RS40 Firmware Update Manual page 2

4. Press and hold the STANDBY button on the projector while plugging in the power cord. The three LEDs
on the projector should be lit to indicate Download Mode.
5. PC detects the projector as new hardware. Then it opens Found New Hardware Wizard to help install
the drivers.
6. In the Hardware Wizard screen, for the question "Can Windows connect to Windows Update to search
for software?" click on "No, not this time", and then click "Next".
7. For the question "What do you want the wizard to do?", click on "Install the software automatically
(Recommended)". Then click "Next".
8. The driver will be installed and a confirmation message is displayed that the installation is finished.
9. If the driver does not install automatically, it can be installed manually. The USB Driver and .INF file can
be found at \Program Files\ILA-FPJ\Updater\X3_V1_2\.
10. When the driver is installed successfully, message "Found New Hardware. Your new hardware is
installed and ready to use."
11. Next step is to update the projector firmware. If you are going to update the firmware immediately after
USB driver installation, leave the projector in Download Mode and proceed to step 3 of the Firmware
Update procedure.