Table of Contents
Advertisement
II-6.
WPS Setup
If your wireless device supports WPS (Wi-Fi Protected Setup) then you can use this
method to connect to the BR-6288ACL's Wi-Fi network.
1.
Press the WPS/Reset button on the BR-6288ACL for
2 seconds to activate WPS. The LED will then quickly
flash orange/red to indicate that WPS is active.
2.
Within two minutes, press the WPS button on the
wireless device/client to activate its WPS.
3.
The devices will establish a connection. Repeat for
additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II-7.
Reset to Factory Default Settings
If you experience problems with your BR-6288ACL, you can reset the device
back to its factory settings. This resets all settings back to default.
1.
Press and hold the WPS/Reset button found on the rear base of the
product for at least 10 seconds.
2.
Release the button when the LED is quickly flashing orange/red.
3.
Wait for the BR-6288ACL to restart.
41
Advertisement
Table of Contents
