Toshiba e-studio 450 Operator's Manual page 272

6.ADDING STAPLES (OPTIONAL) (Cont.)
4
Remove the empty staple case and
replace it with a new one.
- Replace both staple cases with new ones.
5
Return the saddle staple to its original
position.
- Pull the handle of the saddle stitch holder (1) toward you and turn
it (2) 90º in the direction of the arrow.
6
Return the saddle stitch unit to its original
position.
7
Make sure that A3, A4-R or B4 paper is
set.
- If any of the above paper sizes is not set, test stapling cannot be
performed.
8
Close the front cover of the finisher. Then,
test stapling is automatically performed
on a blank sheet.
- This is performed to avoid empty stitching.
12
If there is a test stapling failure and "Check staple cartridge"
remains, repeat the above procedure from step 1 to 8.
270
12.WHEN THE GRAPHIC SYMBOLS BLINK ON THE TOUCH PANEL
( 2 )
( 1 )