Step 3: When the WPS LED is on, the client device has successfully connected to the Router.
Step 4: Refer back to your client device or its documentation for further instructions.
Note:
1)
The WPS LED on the Router will light green for five minutes if the device has been
successfully added to the network.
2)
The WPS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
4.5
Network
Figure 4-5 the Network menu
There are three submenus under the Network menu (shown in Figure 4-5 ): LAN, WAN and MAC
Clone. Click any of them, and you will be able to configure the corresponding function.
TL-WR720N
150Mbps Wireless N Router
-19-