Appliance Doors, Side Panels - Miele KFN 12943 SD edt/cs Operating And Installation Instructions

^ Clean the condensate channel and
drain hole frequently, so that
condensate can drain away
unhindered. Use a straw or similar to
clear the drain if necessary.
^ After cleaning, wipe the interior and
accessories with a damp cloth and
dry with a soft cloth.
Leave the doors open to air the
appliance for a short while.
^ Miele stainless steel conditioning
agent can be used to remove any
soiling.
^ It is important to treat the stainless
steel frames and trim with Miele
stainless steel conditioning agent
each time they are cleaned. This will
protect the surface and help prevent
resoiling.

Appliance doors, side panels

Remove any soiling on the
appliance doors and side panels im-
mediately.
If this is not done, it might become
impossible to remove and could
cause the surface to alter or
discolour.
All surfaces are susceptible to
scratching.
Contact with unsuitable cleaning
agents can alter or discolour the
surfaces.
Cleaning and care
^ The surfaces should be cleaned
using a solution of hot water and a
little washing-up liquid applied with a
soft sponge. They can also be
cleaned with a damp microfibre cloth
(without using any cleaning agent).
^ After cleaning, wipe with a damp
cloth and dry with a soft cloth.
Stainless steel appliances
– Appliance doors
The appliance doors have a high
quality, special finish which is resistant
to soiling and is very easy to clean.
Do not use the following to
clean/condition the doors
– stainless steel cleaning agent:
this will damage the surface.
– Miele stainless steel conditioning
agent:
this will cause noticeable smearing.
– Side panels
^ Use Miele stainless steel conditioning
agent to remove any soiling from
stainless steel surfaces.
^ Make sure you treat the side panels
with Miele stainless steel conditioning
agent each time you clean them.
This will give them a water and dirt
repellent protective coating and help
prevent re-soiling.
39