Miele KFN 12943 SD edt/cs Operating And Installation Instructions page 42

Problem solving guide
. . . food has frozen together.
Use a blunt instrument, e.g. a spoon
handle or plastic scraper, to prise it
apart carefully.
. . . the door to the freezer section
will not open because it has been
opened and closed too many times in
succession.
This is not a fault. The suction caused
by opening and closing the door
several times in succession is
preventing it from opening. Wait a few
minutes and then try again. It should
now open without force.
. . the alarm sounds.
Has one of the the appliance doors
been open for longer than 60 seconds?
^ Close the door.
. . . the alarm sounds and the freezer
section temperature display flashes.
The freezer section temperature has
risen above the set temperature
because
^ the freezer section door has been
opened too frequently, or large
amounts of fresh food have been put
in at once for freezing.
^ the ventilation gaps are blocked.
Once the problem has been resolved
the freezer section temperature display
will light up constantly and the alarm
will go off.
42
. . . the Super freeze indicator light
and one of the temperature display
lights are flashing at the same time.
There is a fault. Call Miele Service.
. . . the interior lighting in the
PerfectFresh zone is not working.
Was the door left open for too long?
The lighting switches itself off
automatically after approx. 15 minutes if
the door is left open.
If this is not the case, then the interior
lighting is defective.
^ Call the Service Department.
The LED lighting may only be repaired
or replaced by a service technician.
There are live electrical components
under the cover. Danger of injury and
damage.
Do not remove the cover. If the
cover is damaged or needs to be
removed due to damage, exercise
caution. There are lasers in the
lighting (laser beam class 1M) which
you should avoid looking at directly.
Do not use optical instruments
(magnifying glass or similar) to look
at the lighting either.
. . . the floor of the refrigerator
section is wet.
The condensate drain hole is blocked.
^ Clean the condensate channel and
drain hole.