Miele KFN 12943 SD edt/cs Operating And Installation Instructions page 55

Changing over the doors
^ Pull complete hinge pin a together
with disc b and adjustable foot c
upwards and off.
^ Remove cover cap d.
^ Undo screws e and take hinge plate
f off.
^ Undo the screw of hinge part h on
hinge plate f slightly. Fit it into the
hole opposite in hinge plate f and
tighten up the screw.
^ Refit cover cap d in the other hole.
^ Remove cover g and fit it into the
holes on the opposite side.
Changing the door hinging
^ Screw hinge plate f into position on
the opposite side using the two outer
long slots only. To make it possible to
align the door later, do not replace
the centre screw at this stage.
^ Important. Screw the adjustable foot
c into hinge pin a as far as it will go.
^ Refit hinge pin a together with disc
b and adjustable foot c. Important.
The notch at the bottom of the hinge
pin should face towards the back.
^ Place the door onto hinge pin a.
^ Close the lower door.
55