KitchenAid KSEG950ESS User Manual page 10

For foods containing sugar in any form, clean up all spills and
soils as soon as possible. Allow the cooktop to cool down
slightly. Then, while wearing oven mitts, remove the spills using
a scraper while the surface is still warm. If sugary spills are
allowed to cool down, they can adhere to the cooktop and can
cause pitting and permanent marks.
To avoid scratches, do not slide cookware or bakeware across
the cooktop. Aluminum or copper bottoms and rough finishes
on cookware or bakeware could leave scratches or marks on
the cooktop.
Do not cook popcorn in prepackaged aluminum containers on
the cooktop. They could leave aluminum marks that cannot be
removed completely.
To avoid damage to the cooktop, do not allow objects that
could melt, such as plastic or aluminum foil, to touch any part
of the entire cooktop.
To avoid damage to the cooktop, do not use the cooktop as a
cutting board.
Use cookware about the same size as the surface cooking
area. Cookware should not extend more than ½" (1.3 cm)
outside the area.
A. Surface cooking area
B. Cookware/canner
C. ½" (1.3 cm) maximum overhang
Use flat-bottomed cookware for best heat conduction and
energy efficiency. Cookware with rounded, warped, ribbed or
dented bottoms could cause uneven heating and poor cooking
results.
Determine flatness by placing the straight edge of a ruler
across the bottom of the cookware. While you rotate the ruler,
no space or light should be visible between it and the
cookware.
Cookware designed with slightly indented bottoms or small
expansion channels can be used.
Make sure the bottoms of pots and pans are clean and dry
before using them. Residue and water can leave deposits
when heated.
To avoid damage to the cooktop, do not cook foods directly on
the cooktop.
Cooktop On Indicator Light
The Cooktop On indicator light is located on the console panel.
When any control knob on the console panel is turned on, the
Cooktop On indicator light will glow.
Hot Surface Indicator Light
On ceramic glass models, the Hot Surface indicator light is located
on the console panel.
The Hot Surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area is turned off.
B
A
C
Dual Zone Cooking Element
The Dual Zone cooking element offers flexibility depending on the
size of the cookware. Single size can be used in the same way as
a regular element. The dual size combines both the single and
outer element and is recommended for larger size cookware.
A
NOTE: Settings are marked on the control knob.
Rapid Boil Element (Right Front Element)
The Rapid Boil cooking element offers additional cooking flexibility.
The Rapid Boil element can be used to boil liquids faster. The
lowest melt setting can be used to prepare sauces, to brown or
saute foods and to keep foods at a low temperature. Use cookware
appropriate in size for the Rapid Boil cooking element.
A
NOTE: Settings are marked on the control knob.
Melt Element (Left Rear Element)
The Melt cooking element offers flexibility due to a wide range of
settings between High and Melt. The High heat option can be used
to boil small amounts of liquid quickly. To reduce the power setting,
turn the knob clockwise. The Melt setting is designed for delicate
foods that require low heat, such as when melting chocolate or
holding sauces. Use cookware appropriate in size for the Melt
cooking element.
A
NOTE: Settings are marked on the control knob.
10
B
A. Dual
B. Single
Off
B
A. Rapid boil option
B. Lower heat option
Off
B
A. High heat option
B. Melt option