Troubleshooting Hints - Toshiba FT-8930 Service Manual

1. The bell does not ring.
Check RINGER ON/OFF SW
on Base to ON position.
OK
When the PAGE SW of the
base is pressed, does the
ringer on the handset ring?
OK
When the TEL SG is joined
with the base to make bell
signal, is there pulse wave at
pin 4 of IC2?
OK
Is there pulse wave at
pin 21 of IC11?
OK
Check IC11 and its
peripheral circuit.
If you want to reset the unit to the factroy settings
You can cancel the OGM, PIN, and the clock settings by the following process.
1 Disconnect the AC adaptor and telephone line cord from the base. Keep the AC adaptor connected to the wall
outlet. Make sure that the telephone line cord remains disconnected during this procedure.
2 Set the TONE/PULSE switch to TONE mode. While pressing the DELETE button, plug the AC power adaptor
into the base. Keep pressing the DELETE button for more than 4 seconds.
A beep sounds and " P" blinks in the LED display.
To resume using the unit, connect the telephone line cord and place the handset on the base.
Note:
If you turn on the unit again, " P" may flash.

TROUBLESHOOTING HINTS

Set RINGER ON/OFF SW on
NG
Base ON Position.
See 2. The bell does not ring
NG
& page does not ring.
NG
Check IC2 and TEL network
circuit.
NG
Check R78,R82 and R94.
16