Supero 5018A-MLHN4 User Manual page 86

SUPERSERVER 5018A-MLHN4 User's Manual
SATA Mode
This item selects the mode for the installed SATA drives. The options are IDE and
AHCI.
IDE Mode (Available when the item above: SATA Mode is set to IDE)
Select Legacy for the SATA port specifi ed by the user to support a Legacy SATA
device. The options are Legacy and Native.
SATA 3 Speed
Use this item to set the highest speed allowed for SATA interface connections for
SATA 3 controller. The options are Gen 1, Gen 2, and Gen 3.
LPM (Line Power Management)
Select Enabled to enable Line Power Management support. The options are En-
abled and Disabled.
SATA Port0/Port1
This item displays the information detected on the device installed on the par-
ticular SATA port.
•
Model Name
SATA Port0/Port1
Select Enabled to enable a SATA port selected by the user. The options are
Enabled and Disabled.
Spin Up
On an edge detect from 0 to 1, set this item to allow the PCH to start a COM-
RESET initialization sequence to the device installed on a SATA port specifi ed
by the user. The options are Enabled and Disabled.
External Device
Select Enabled for the SATA port specifi ed by the user to support an external
device. The options are Enabled and Disabled.
Hot Plug
Select Enabled to enable hot-plugging support on a SATA drive specifi ed by the
user, which will allow the user to replace the SATA disk drive without shutting
down the system. The options are Enabled and Disabled.
7-6