Related Manuals for Nakamichi NA2800
Summary of Contents for Nakamichi NA2800
- Page 1 NA2800/NA2820 AV Media Receiver User Manual Enjoy the Lifestyle of In-Car Entertainment...
-
Page 2: Table Of Contents
Contents Thank you for purchasing a Nakamichi products. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. INTRODUCTIONS ACCESSORIES…………………………………………………………………………………………………………………………..2 INSTALLATION………………………………………………………………………………………………………………………….3 WIRING CONNECTIONS…………………………………………………………………………..………………………………..4 FRONT PANEL…………………………………………………………………………………………………………………………..6 REMOTE CONTROL……………………………………………………………………………………………………………………7 REMOVE BATTERY…………………………………………………………………………………………………………………..10 BASIC OPERATIONS MAIN MENU…………………………………………………………………………………………………………………………...11... -
Page 3: Accessories
Accessories Package contains the following accessories for installation and operation of the unit. (1) Washer, Spring (5) Rubber 1 each Washer, M5 cushion (2) Mounting (6) Screw Strap (3) Bolt (7) key (4) Screw (8) sleeve External Microphone Cable Power Cable Remote Control Trim Ring User Manual... -
Page 4: Installation
Installation Note Before starting installation of the unit, make sure the wiring is connected properly. Use only the parts provided with the unit to ensure proper installation. The use of unauthorized parts may cause malfunction. Install the unit where it does not get in the driver’s way and will not injure the passenger in case there is a sudden stop, like an emergency stop. -
Page 5: Wiring Connections
Wiring Connections NOTE: Never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: 1. - Page 6 Wiring Connections After connecting, when you start up the reverse gear, the unit will receive the picture from car rear view camera. Note: Only use groundless loudspeakers. Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loudspeakers at higher volumes.
-
Page 7: Front Panel
Front Panel 1. IR Sensor IR Remote control signal receiving window. Max distance is 6-8 meters, 45 angels. 2. VOL Increase Button Press VOL increase button to increase the volume. 3. POWER/MUTE Button Press it to turn on the unit. Press and hold for 2 seconds to turn the unit off .Press the button briefly to Mute .Please note that the volume will be muted on all audio output connector. -
Page 8: Remote Control
3: BAND/RANDOM/CLEAR 4: ENTER 5: UP/DOWN/LEFT/RIGHT 6: EJECT 7: PTY/*/LOC 8: P.SCN/RPT/# 9: BACKWARD/SEEK-/FAST BACKWARD 10: AF/TA/LOUD (Only with AF/TA function for NA2800/NA2820) 11: OSD 12: PBC/STOP 13: DIGIT NUMBERS 14: PLAY/PAUSE 15: MUTE/BLUETOOTH 16: MENU 17: SUBTITLE 18: SETUP... - Page 9 Remote Control In SD CARD/ USB/DVD mode, press to repeat REP 1 => REP DIR => REP ALL In Radio mode: PS (Preset Scan): Press to scan all preset stations in the memory of the current band and stay on each memory stations for about 5 seconds.
- Page 10 Remote Control During playback, press it at the starting point of section you want to repeat (A), press this button again at the ending point of the section you want to repeat (B), section A-B repeating starts. Press it again to cancel the A-B repeat function.
-
Page 11: Remove Battery
Remove Battery Note: The distance may vary according to the brightness of ambient light. If the remote is not used for an extended period of time, remove the battery to prevent possible damage from battery leakage and corrosion. Do not place any objects between the remote control unit and the sensor on the unit. -
Page 12: Main Menu
This is the root of the screen hierarchy, and you can simply access all features by tapping on the touch screen buttons. Tap the icons to enter a desired mode. Model：NA2800 Model：NA2820 ◆ RADIO PLAYER To start Radio, tap RADIO button on main menu screen. -
Page 13: Dvd Player
DVD Player ◆ DVD PLAYER To start DVD Player, tap on DVD button from main menu screen. TOUCH SCREEN MENU You will not see any buttons while DVD is played. Buttons will appear when you tap on TFT screen. Tap the screen again to hide the buttons. -
Page 14: Disc/Usb/Sd/Mmc Interface
Disc/USB/SD/MMC Interface When a file disc, USB or a memory card is played, the screen will show following interface: Press it to activate the intro function. You can play the beginning of every track for 10 seconds in sequence. Press it to repeat REP 1 => REP DIR => REP ALL. Press it to play track randomly. -
Page 15: Setting Control
Setting Control ◆SETTING CONTROL Your device has default system settings. You can customize the settings to suit your personal needs. Once you change settings, your new settings will remain until you change it again. To start SETTING, tap it on main menu. Tap SOUND button to show SOUND1 menu. -
Page 16: Radio Control
Setting Control button to show GENERAL 2 menu. CLOCK HOUR Set 24Hour format or 12Hour format CLOCK Adjust clock display SETTING AUTO Set AUTO CONNECT CONNECT ON or OFF RADIO CONTROL Tap RADIO button to show RADIO menu; AREA Select Europe, USA, South America or Russia Select ON (stereo reception mode) or OFF (mono reception). -
Page 17: System Information
Setting Control With this option you can select the preferred language for the disc menu. When the selected language is recorded on the disc then this language will automatically be selected. If not, the first language recorded on the disc is displayed. -
Page 18: Other Functions
Other Functions Subwoofer Connect the subwoofer to the unit using sub output (see electrical diagram). Tap MENU on screen enter into main menu setting choose setting menu. Choose SOUND and set subwoofer ON to enable subwoofer. Parking When the car is stopped and the parking brake is working, the screen can display the video image, otherwise the screen can't display the video image Back View Camera This unit is equipped with back view camera output. -
Page 19: Bluetooth Section
Bluetooth Section Warning: Driving and having a Telephone conversation at the same time is dangerous, please park your car before having a telephone conversation. The supplier waves any and all liability when this warning is not followed. Before using the Bluetooth function, please connect the external microphone to the MIC PHONE JACK on the back of the device as the rating label shows. - Page 20 Bluetooth Section Voice Transfer During a call, you can change a call from Bluetooth mode to phone by tapping Transfer button. To have a call in Bluetooth mode again, tap Transfer button. NOTE: the phonebook only supports Western Characters. Any difference in character will be shown such as “+, * or #”.
-
Page 21: Tv Operation
TV Operation (Only for NA2820) To start TV mode, tap on TV button from main menu screen. Connect a TV antenna to the TV antenna jack of the unit. Select TV mode; press on the center of the touch screen, and following interface will be display: 1. - Page 22 TV Operation (Only for NA2820) System Select this menu item is to set TV system: SECAM => NTSC =>PAL, press ENTER button on the remote or tap the screen to select. Audio Select this menu item is to set the TV sound system: When system setting PAL, press ENTER on remote or tap the screen button to select TV sound system: D/K=>M/N=>...
-
Page 23: Swc Mode
SWC Mode To start SWC function, tap on SWC icon from setting menu screen. 1) First check whether the car has steering wheel button. 2) The steering wheel and the unit must be connected on the line connecting the SWC. Wiring diagram below. 3) Open the unit SWC interface, you can in the above operation, the interface is as follows. -
Page 24: Notes On Disc
Notes on Disc Only use groundless loudspeakers. Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loud speakers at higher volumes. Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body. -
Page 25: Troubleshooting
Trouble Shooting Symptom Cause Remedy Replace with fuse of the same amperage. If the Fuse is blown Power does not turn on. fuse blows again, consult your store of purchase (No sound is produced.) In correct wiring Consult your local retailer. 1. - Page 26 Trouble Shooting SYMPTOM CAUSE SOLUTION IF THE POWER SUPPLY IS PROPERLY THE CAR IGNITION IS NOT CONNECTED TO THE CAR ACCESSORY SWITCH THE IGNITION KEY TO NO POWER “ACC”. THE FUSE IS BLOWN. REPLACE THE FUSE. DISC CANNOT BE PRESENCE OF DISC INSIDE REMOVE THE DISC IN THE PLAYER THEN LOADED.
-
Page 27: Technical Specifications
Technical Specifications General Power supply :11~16V DC Current consumption :max. 10 A Maximum power output :50W x 4 channels (max) :DVD/SVCD/VCD/HDCD/MP3/MP4/VIDEO/CDDA/PICTURE Compatible formats CDCD-R/-RW/DVD±R/±RW PLAYBACK Dimensions (W x D x H) / weight :165*178*100 mm/2 kg Working temperature range :-20℃ - +60℃ ESP function :10 sec.