Setting Product-Id - Fujitsu M3099A Operator's Manual

3.9
Setting Product-ID (M3099G)
When you set the Product-ID, you must set as follows.
@At Screen 2, press [Mode 11 six times to go to
<< SETUP MODE >>
the PRODUCT-ID SET screen. (Screen 20)
t------------------------------------------~
PRODUCT-ID SET
@ Press [Mode 21 to see Screen 21. (The default
Screen
20
setting is "M3099G".)
@At
Screen 21, the Product-ID
is M3099G or
:/
M3096G each time you press [Mode 11.
@ f:,csssdkd$ :;;gicreen 20. The setting
Screen
21
@When
you close the setup mode, go to @.
3.10 Setting initial value of endorser
When you set the using of endorser and the initial number, you must see
Section 2.1 and 2.2 of Appendix B. The details is as follows.
l
The using of Endorser (ON/OFF)
The default setting is "OFF" (Endorser is not used.)
l
The initial number
The default setting is "00000". The specifiable range is from 00000 to
65535.
NOTICE: If the specified value exceeds acceptable range, returning
to SETUP menu is failed.
<Method of Increment>
In case of the initial value is "00001".
-+00001
(I page)
00002
(2
pages)
i i
65534 (65534 pages)
65:35
(65545 pages)
M3099A/G
Operator's Guide c-7