Haier HW-12C03 Service Manual page 102

Installation instruction
Selection of the installation position
1. Select position where the structure is firm.
2. Select position where the air inlet and outlet are smooth without obstacles.
3. Select position where the cooled air can be blown to every corner .
4. Select position where there's no direct sunlight. If the sunlight is inevitable. sunshading device
is required.
5. Select position where the outdoor airflow will not influence the neighbors.
6. Select position where the drainage is smooth.
7. Select position where there's no dangerous gas or oil smoke nearby.
8. An extention cord is not recommened.
Installation diagram
It should be installed like this; the back side(outdoor side) is lower so that the drained water can
flow out smoothly.
Width of the wall should be
less than 295mm
Requirements on electricity
Be sure to use specific power circuit.
The enclosed accessories of the conditioner are:
Name Manual
Figure
1
Quantity
Water outlet pipe Drain elbow
For HW-10XXX For HW-09XXX
HW-12XXX HW-07XXX
HW-18XXX HW-08XXX
1
Rubber lid
seal ring
For HW-10XXX
1 1
105
Screw
Drain pan
For HW-07XXX
HW-12XXX HW-09XXX
HW-18XXX HW-08XXX
1 1
4 6
4