Avocent DSR1031 Quick Installation Manual page 2

The following instructions will help you
to connect your DSR switch.
Should you require further assistance, please
consult your installer/user guide.
7
Connecting the SPC device to the
DSR switch (optional)
Plug one end of the cable supplied with the SPC
power control device into the SPC1 port on the DSR
switch and plug the other end into the SPC device.
Plug the power cords from the target servers into the
SPC power outlets. Plug the SPC device into an
appropriate AC wall outlet.
8
Powering up targets and switch
Power up each target server and then power up the
DSR switch.
9
Connecting local virtual media
(optional)
Connect virtual media devices to any of the five USB
ports on the DSR switch.
NOTE: To open a virtual media session with a
server, the server must first be connected to the
switch using a virtual media-capable DSRIQ
module (USB2 or USB2L).
For additional information
For further instructions on DSR switch connection,
software setup and security configuration, please
refer to the installer/user guide included with the
switch. Check http://register.avocent.com for the
latest DSR switch software and firmware updates.
To Contact Avocent Technical Support
Avocent, the Avocent logo, The Power of Being There and DSR are registered trademarks of Avocent Corporation. All other marks are the property of their respective owners. © 2005 Avocent Corporation. All rights reserved.
Quick Installation Guide
DSR ® Switch
DSR1031 Switch
To connect a DSR1031 switch
(continued from reverse side)
SPC Power
Control Device
CALL (888) 793-8763
or
DSR Switch
1 2
7
Connect your
SPC device to
the target servers
(optional).
Server
Server
Server
Server
VISIT www.avocent.com/support
The Power of Being There
External Virtual
Media Device
Plug in virtual media
devices to the USB
3 4 5 6 7 8
ports (optional).
8
Power up target
servers and then
the DSR switch.
DOWNLOAD www.avocent.com