Adjustments; Turning On The Projector; Adjustments After Parts Replacement - Sanyo PLC-XE40 Service Manual

Adjustments

Turning On the Projector

If the PIN code is set on the projector, you cannot use the projector. The PIN code can be reset to the factory default
setting (1234) according to the following procedure.
When you reset the PIN code, the Logo PIN code and key lock will be reset, as well.
1. Connect the AC power cord from the AC outlet. The projector is in the standby mode.
2. Press and hold the 7 and 8 button on the remote control at the same time for more than 20 seconds.
3. Turn the projector on with the
Please refer to the owners manual for further information.

Adjustments after Parts Replacement

Contrast Adjustment
R-Contrast adjustment
G-Contrast adjustment
B-Contrast adjustment
Integrator lens adjustment
Relay lens-out adjustment
Panel type check and setting
Fan control adjustment
Pedestal adjustment [PC]
Gain adjustment [PC]
Pedestal adjustment [1080i]
Gain adjustment [1080i]
Gain adjustment [Video]
Black reference adjustment
Common center adjustment
50% white adjustment [PC]
White balance adjustment [PC]
50% white adjustment [Video]
White balance adjustment [Video]
White uniformity adjustment
ON-OFF
button, enter the PIN code "1234" (the factory default setting).
Disassembly / Replaced Parts
Integrator
LCD/
Prism Ass'y Lens (OUT)
Lens (OUT)
❍ ●
❍
●
●
●
❍
●
❍
❍
-20-
● : Adjustment necessary
Polarized glass
Relay
R G B
●
●
●
●
❍ : Check necessary
Power
Main Board
Board
●
● ●
●
●
●
●
●
●
●
●
❍
●
❍
❍