Indicator Of Program Sequence; Childproof Lock; Selecting A Different Program; Cancel Program - Bosch WTG86401UC Use And Care Manual / Installation Instructions

If DR indicator lights up, check the drain hose and
▯
its connection.
~ Maintenance of drain hose; Page 30
If required, select Low Heat by pressing the button.
3.
~ Additional Program Option settings; Page 27
If required, select Wrinkle Block by pressing the
4.
button.
~ Additional Program Option settings; Page 27
Tip: The estimated remaining time will be updated.

Indicator of program sequence

Bosch dryers use an advanced control system with a
moisture sensor continually monitoring the laundry's
remaining moisture.
The current state of the process and status of the
program is shown by indicator lights (Damp,
End).

Childproof lock

You can secure the dryer against inadvertent changing of
the set functions. To do this, activate the childproof lock
after cycle start.
To Activate/Deactivate, touch Time Dry and Finish in
buttons at the same time for 3 seconds. In the display
field, you will see the
D
childproof lock is active.
NOTICE: The childproof lock will remain activated until
the next cycle start even after switching the machine off.
You must deactivate the childproof lock before the next
cycle and, if necessary, activate it again after starting the
cycle.

Signal

For switching the buzzer on and off touch the Signal
button.
The buzzer indicates program end if it is activated.
Other alarms are not influenced by this option.
You can also change the following settings:
volume for buzzer
▯
volume for button signals
▯
To change these settings always activate adjustment
mode first.
24
, Dry,
=
symbol light indicating the

Selecting a different program

If you have inadvertently started the wrong program, you
can change this as follows:
Touch Start/Pause.
1.
Select another program.
2.
Touch Start/Pause. The new drying cycle starts from
3.
the beginning.

Cancel program

If required, you can cancel the selected program:
Touch Start/Pause.
1.
Rotate the program selector to Off.
2.

Program end

End appears in the display area and the Start/Pause
button indicator lamp is off.
After the program end, rotate the program selector to
Off.
Removing laundry/switching the
appliance off
Open the door and remove the laundry.
1.
Turn the program selector to the Off position.
2.
Appliance is switched off and dryer light goes out.
Clean lint filter.
3.
~ Cleaning the lint filter; Page 28
Close the door.
4.
Tip: If at the end of the drying cycle the display does not
light, the energy-saving mode is active. To see diplay,
e.g. press any button.
~ Environmentally friendly use of your dryer; Page 7
Activate adjustment mode
Select Cotton Extra Dry on position 1.
1.
The appliance is on.