Bosch WTG86401UC Use And Care Manual / Installation Instructions page 32

Problem
Water is leaking out.
Program terminates
shortly after starting.
The door opens by
itself.
Creasing.
Drying result is not sat-
isfactory (laundry feels
too damp).
Drying time too long.
Program does not start
Finish in (remaining)
time is displayed.
Program does not start
- D symbol lit up.
32
Possible cause(s)
Dryer is not leveled.
The heat exchanger seal is dirty.
Drain hose is leaking.
Laundry is not loaded.
Load too small for selected pro-
gram.
Loaded laundry is too dry.
The door not closed properly.
Laundry load exceeded.
Unsuitable program selected.
Warm laundry may feel more damp
than it really is.
The selected program does not suit
the load.
Dryness level is not adjusted.
Fine layer of limescale on the mois-
ture sensors.
Program termination e.g. main
power supply failure, door open or
maximum drying time reached.
Initial load is too wet.
Lint filter and/or Heat Exchanger is
dirty.
Insufficient supply of air.
Air inlet possibly blocked.
Ambient temperature higher than
° °
95 F/35 C.
A delayed starting time has been
selected and activated.
Childproof look is activated.
Solution(s)
Level the dryer.
~ Leveling the dryer; Page 15
Clean the heat exchanger seal.
~ Cleaning the heat exchanger; Page 29
Check entire length of drain hose for leaks; replace if
necessary.
Check that hose is clamped on hose barb at back of
the dryer securely.
Load the laundry.
~ Loading the laundry; Page 23
Use time program.
~ Program selection table; Page 26
Check the loaded laundry. If it is dry, open the door,
remove laundry and turn program selector to Off.
Close the door until a click is heard.
Do not exceed the maximum load for selected pro-
gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Turn program selector to Off.
~ Program selection table; Page 26
Remove items of laundry immediately after the end of
the program and turn the program selector to Off.
Use another drying program or, in addition, select the
time program.
~ Program selection table; Page 26
Use Dry Level to adjust the dryness level.
~ Dry Level; Page 27
Clean the moisture sensors.
~ Cleaning the moisture sensors; Page 30
See the problem(s) mentioned in this table.
Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer, and than turn it on again.
Clean lint filter
~ Cleaning the lint filter; Page 28
and/or Heat Exchanger.
~ Cleaning the heat exchanger; Page 29
Ensure that air can circulate.
Do not obstruct the air inlet on the front of the dryer.
Ventilate the room.
Drying cycle will begin at proper time to complete at
the selected Finish in time.
Deactivate Childproof look.
~ Childproof lock; Page 24