Table of Contents
Advertisement
- Swing-away, removable n°2 (photos 14 & 15)
This range of armrests can be swung away to facilitate
transfers and disassembling during transport.
To swing the armrest away, push down the dog point (A),
reverse the procedure to reinsert making sure that the dog
point (B) is properly engaged in its housing.
To remove the armrest, swing it back completely and pull it
up. Reverse the procedure to reinstall.
The new design includes handle (C) and hollowed skirt-guard
(D) to facilitate front transfer.
Grip firmly the armrest handle, take care of your nails on the
skirt-guard edges.
Push on your arms to easily lift yourself up and the attendant
24
can help you to finalise the transfer to the place where you
wish to sit.
In the event the armrest handle covers (C) become slippery, it
is recommended to request your dealer to replace them.
Refer to paragraph 1.2.2. Front transfer for safety
instructions.When folding back down, ensure that it locks in
place, otherwise it can act as a long lever and could fatigue.
C
A
B
D
14
15
- Ajustable tubular n°3 (photo 16) :
Identical to the previous procedure including armrest height
and depth adjustment ; slightly loosen the ball screw (B),
adjust for the desired height based upon the preset holes
and firmly tighten the screw ; slightly loosen the two screws
(C) and slide the armrest down for the desired depth, firmly
tighten the two screws (C).
Note : the armrests are mounted in pairs on the wheelchair ;
whenever you remove them, remember that you have a right
and a left side !
Never lift the wheelchair by the armrests !
Keep your fingers away from movable parts during folding,
disassembling or adjusting to prevent injuries !
C
B
16
Advertisement
Table of Contents
