Image Adjustment - Sanyo PLC-HF15000L Owner's Manual

Chapter 4 Controlling the Projector

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.
Item Description
Contrast .................................Adjusts picture contrast.
Brightness ............................Adjusts picture brightness.
Color.........................................Adjusts picture color satura-
Tint ............................................Adjusts picture hue. (0~ 63)
Color temp...........................Sets a color temperature
White balance
Red, Green, Blue..........Adjusts each white balance
* When changing the value of the white balance,
the color temp. indicates "Adj."
Offset
Red, Green, Blue..........Adjusts each offset respec-
Auto picture control .....Sets auto picture control
Advanced color ................Applies improved color
Sharpness.............................Adjusts picture sharpness.
Gamma .....................................Adjusts brightness of darker
Noise reduction.................Switches noise reduction mode (ON, OFF)
Progressive.................................. Switches progressive mode (OFF, ON, Film)
Reset.........................................Resets the Image adjustment to previous levels.
Store.........................................Stores the Image adjustment values. Select an item [Image1 - Image10] from
Load Image mode ..........Loads the Image mode. Select an image mode from the pull-down menu
Input source
Image mode Video Computer
Standard
Cinema
Real
Dynamic
Image1 - 10
36
(0~ 63)
(0~ 63)
tion. (0~ 63)
mode. (X Low, Low, Mid, High,
Adj.)
respectively. (0~ 63)
tively. (0~ 63)
level. (OFF, L1, L2)
adjustment with yellow
light controller. (Auto, OFF)
(0~ 31)
part of the picture. (0~ 15)
the pull-down menu and click Store button.
and click Load button. There may not be available mode depending on the
input mode as shown in the table left.
* When Edge blending is set to "ON", Auto picture control and
* When Color matching is set to "ON", Auto picture control,
*
*
Advanced color are disable.
Advanced color, Color temp., White balance and Offset are
disable.
The mark " " means that the available image mode in the
selected input source. The error message appears when
selecting the disabled image mode indicated with "*".