Sceptre E325 Series User Manual

PACKAGE CONTENTS

SCEPTRE Display x 1
Display Base x 1
Display Neck x 1
User Guide x 1
Screw Type 1 for Display Neck (fine threaded) x 4
Screw Type 2 for Display Stand (thick threaded) x 4
Circular Metal Plate x 1
Power Cord x 1 (Attached)
Warranty Card x 1
Display Remote Control (AAA Batteries included) x 1
ATTACHING & REMOVING THE BASE
1. Place the display unit flat on a table. Afterwards attach the plastic base onto the neck by form fitting the
circular hole. Remember the plastic base should have more area facing the front of the neck. Fit the
metal plate onto the bottom of the base by matching the 3 holes. Screw in the 4 thick threaded screws to
secure the metal plate to the plastic base. The stand installation is now complete.
2. To install or remove the stand, screw in or remove the 4 screws indicated in the picture and the stand will
come off.
3. To finalize your installation of the Display, please read the following:
a. If you are placing the Display on a stand, we would recommend you to use a Display safety
strap (not included) in order to minimize the possibility of the Display toppling over.
b. If you are mounting the Display on the wall
c. Make sure the wall is structurally safe for the weight of the Display
d. Make sure the wall mount kit is compatible with the Display
e. Read and follow all instructions provided by the wall mounting kit.
f. Securely install all screws and connections.
E325 Series User Guide
MQR Color Series P1
Type 1 Type 2