Toyostove Laser 300 A Installation And Operation Instructions Manual page 31

9. A room temperature sensor is provided with approx. eight (8) feet long extension wire. It is located on the rear
of the cabinet. Make sure that the extension wire is not touching the exhaust pipe. The room temperature sen-
sor can be installed either with the self adhesive tape on the back or with a wood screw provided with the sen-
sor depending on the type of surface chosen for installation.
NOTE: Choose a location for the sensor that is not in the path of direct sunlight, drafts or the flow of warm air
from the heater.
(a) Self Adhesive Tape
Peel off the protective tape on the back of the sensor and expose the
adhesives. Place the sensor on the desired location on the wall and press
down.
(b) Wood Screw
Screw down the wood screw provided with the heater into the desired
location on the wall. Hook the back of the room temperature sensor.
10. After installation is completed, secure heater to the wall with the wall brackets provided with the heater. Make
sure the heater is parallel to the wall (See Fig. 13).
11. Before ignition, recheck the following:
a. All connections are tight and firm.
b. The heater and the flue pipe areas are free of any materials.
c. The heater is level and parallel to the wall.
d. The exhaust and the intake holes of the standard flue pipe are fully exposed to outdoor air, but not protruded
too far from the wall sleeve.
Fig. 13
31