Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hotpoint HXT4X
Summary of Contents for Hotpoint HXT4X
- Page 1 Instructions for use English, 10 HXT4X...
-
Page 10: General Safety
English The hood can look different to that illustrated in the drawings in this ELECTRICAL CONNECTION booklet. The instructions for use, maintenance and installation, however, The mains power supply must correspond to the rating indicated on the plate remain the same. situated inside the hood. -
Page 11: Display Symbols
In case the filtering version hood is used, it is necessary to enable the carbon CONTROLS filter signalling. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to Activation of carbon filter signalling: cooking and to leave in operation during cooking and for another 15 minutes Set the hood to OFF and keep keys “2”... -
Page 12: Maintenance
• Montage MAINTENANCE Install the carbon filter on the back of the grease filter and fix with two rods. ATTENTION! Before performing any maintenance operation, isolate the hood Attention! The rods are included in the carbon filter packing and not on the from the electrical supply by switching off at the connector and removing the hood. -
Page 13: Technical Data
If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service. TECHNICAL DATA Model HXT4X Height 80.2 cm Width 43 cm Depth 50 cm... - Page 16 LIB0019223 01/2011...
Need help?
Do you have a question about the HXT4X and is the answer not in the manual?
Questions and answers