Maintenance And Storage; Toro Mower Safety - Toro Greensmaster 3420 TriFlex Operator's Manual

•
Stop the blades from rotating before crossing surfaces
other than grass.
•
When using any attachments, never direct discharge of
material toward bystanders nor allow anyone near the
machine while in operation.
•
Never operate the machine with damaged guards, shields,
or without safety protective devices in place. Be sure all
interlocks are attached, adjusted properly, and functioning
properly.
•
Do not change the engine governor settings or overspeed
the engine. Operating the engine at excessive speed may
increase the hazard of personal injury.
•
Before leaving the operator's position:
– stop on level ground;
– disengage the power take-off and lower the
attachments;
– change into neutral and set the parking brake;
– stop the engine and remove the key.
•
Disengage drive to attachments when transporting or not
in use.
•
Stop the engine and disengage drive to attachment:
– before refuelling;
– before removing the grass catcher/catchers;
– before making height adjustment unless adjustment
can be made from the operator's position.
– before clearing blockages;
– before checking, cleaning or working on the mower;
– after striking a foreign object or if an abnormal
vibration occurs. Inspect the mower for damage
and make repairs before restarting and operating the
equipment.
•
Reduce the throttle setting before stopping the engine
and, if the engine is provided with a fuel shut-off valve,
turn the fuel off at the conclusion of mowing.
•
Keep hands and feet away from the cutting units.
•
Look behind and down before backing up to be sure of
a clear path.
•
Slow down and use caution when making turns and
crossing roads and sidewalks. Stop the reels when not
mowing.
•
Do not operate the mower under the influence of alcohol
or drugs.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Use care when approaching blind corners, shrubs, trees,
or other objects that may obscure vision.

Maintenance and Storage

•
Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
•
Never store the equipment with fuel in the tank inside a
building where fumes may reach an open flame or spark.
•
Allow the engine to cool before storing in any enclosure.
•
To reduce the risk of fire hazard, keep the engine,
silencer/muffler, battery compartment, and fuel storage
area free of grass, leaves, or excessive grease.
•
Replace worn or damaged parts for safety.
•
Check the grass catcher frequently for wear or
deterioration.
•
Keep all parts in good working condition and all hardware
and hydraulic fittings tightened. Replace all worn or
damaged parts and decals.
•
If the fuel tank has to be drained, do this outdoors.
•
Be careful during adjustment of the machine to prevent
entrapment of the fingers between moving blades and
fixed parts of the machine.
•
Disengage drives, lower the cutting units, set parking
brake, stop engine and remove key. Wait for all movement
to stop before adjusting, cleaning or repairing.
•
Clean grass and debris from cutting units, drives, mufflers,
and engine to help prevent fires. Clean up oil or fuel
spillage.
•
Use jack stands to support components when required.
•
Carefully release pressure from components with stored
energy.
•
Disconnect battery before making any repairs. Disconnect
the negative terminal first and the positive last. Reconnect
positive first and negative last.
•
Use care when checking the reels. Wrap the reels or wear
gloves, and use caution when servicing them.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Charge batteries in an open well ventilated area, away
from spark and flames. Unplug charger before connecting
or disconnecting from battery. Wear protective clothing
and use insulated tools.

Toro Mower Safety

The following list contains safety information specific to Toro
products or other safety information that you must know that
is not included in the ANSI standards.
This product is capable of amputating hands and feet and
throwing objects. Always follow all safety instructions to
avoid serious injury or death.
Use of this product for purposes other than its intended use
could prove dangerous to user and bystanders.
Operation
•
Know how to stop the engine quickly.
5