Adding Rear Weight - Toro Greensmaster 3420 TriFlex Operator's Manual

9. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 12), push the suspension arm
down so that the bar fits over the bar across the top of
the cutting unit (Figure 13).
1
Figure 12
1. Latch—closed position
2. Suspension-arm bar
1
2
Figure 13
1. Suspension-arm bar
10. Close the latches down and around the cutting-unit bar
and lock them in place (Figure 12).
Note: A "click" can be heard and felt when the latches
are properly locked in place.
11. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 14).
12. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure 14).
2
3. Latch—open position
2. Cutting-unit bar
3
g014609
1. Reel motor
2. Spline shaft
13. Mount a grass basket onto the basket hooks on the
suspension arm.
14. Repeat this procedure for the other cutting units.
15. Connect the cutting unit power
disconnect couplers; refer to
Cutting Unit Power Disconnect Connectors (page 23).
7
g01461 1

Adding Rear Weight

Parts needed for this procedure:
Weight kit, 121–6665 (purchase seperately) Note: not
1
required for units with the 3 wheel drive kit installed.
Procedure
This unit complies with the ANSI B71.4-2004 and EN 836
Standards when equipped with weight kit 121–6665.
Note: If the unit is equipped with a three wheel drive kit
additional weight is not required to meet ANSI B71.4-2004
and EN 836 standards.
16
Figure 14
3. Cavity
4. Motor retaining bar