Ignition Switch; Throttle Control; Backlap Switch - Toro Greensmaster 3420 TriFlex Operator's Manual

1
Figure 16
1. Traction pedal—forward
2. Traction pedal—reverse
Figure 17
Ground speeds are as follows:
•
2 to 5 MPH (3.2 to 8 km/h) forward mowing speed
•
10 MPH (16 km/h) maximum transport speed
•
2.5 MPH (4.0 km/h) reverse speed
Steering Arm Locking Pedal
Press the pedal (Figure 16) and raise or lower the steering
arm for operator comfort, then, release the pedal to lock the
arm in place.
Note: Move the steering arm fully forward before lifting
the seat.

Throttle Control

The throttle control (Figure 18) gives the operator the ability
to control the speed of the engine. Moving the throttle
control toward the Fast position increases the engine RPM;
moving the throttle control toward Slow will decrease the
engine RPM.
2
g014603
3. Steering arm locking pedal
Note: The engine cannot be stopped by the use of the
throttle control.
4
3
5

1. Ignition switch

2. Functional control lever
3. Raise/Lower Mow Control
Raise/Lower Mow Control
Moving the control (Figure 18) forward during operation
lowers the cutting units and starts the reels. Pull back on the
control to stop the reels and raise the cutting units. During
operation the reels can be stopped by pulling back on the
control momentarily and releasing it. This feature is known as
Tap-off and is adjustable in the InfoCenter. Restart the reels
by moving the control forward.
Functional Control Lever
The functional control lever (Figure 18) provides two traction
selections plus a Neutral position. It is permissible to shift
from mow to transport or transport to mow (not to neutral)
while the machine is in motion. No damage will result.
•
Rear Position—neutral and backlapping
•
Middle Position—used for mowing operation
•
Front Position—used for transport operation
Ignition Switch
Insert the key into the switch (Figure 18) and turn it clockwise
as far as possible to the Start position to start the engine.
Release the key as soon as the engine starts; the key will move
to the On position. Turn the key counterclockwise to the Off
position to stop the engine.

Backlap Switch

The backlap switch is located under the plastic cover to
the left of the seat. Use the backlap switch (Figure 19) in
18
3
G017975
Figure 18
4. Throttle
5. InfoCenter
2
1