DinRearMount - Jensen DMR2116i Owner's Manual

DINRearMount(MethodB)
This method of installation uses the screw holes at the sides of the unit and the
holes of the existing vehicle mounting bracket. This is only intended as a general
guide; contact the vehicle's manufacturer for specific instructions.
NOTE: Outer trim frame, hook, and mounting sleeve are not used for this
installation.
1. Remove the hooks on both sides.
2. Align the screw holes of the mounting bracket supplied with the car and the
screw holes of the main unit. Tighten the two screws on each side of the unit.
Then fasten the brackets to the car.
3. Attach the wires of the unit to the existing speaker wires. See the wiring
diagram.
12