LG TD-C801H Owner's Manual page 7

Installation Instructions
Stacking Kit
In order to stack this dryer to an LG front
load washer, an LG stacking kit is required.
Dryer
Washer
This dryer may only be stacked on top of an
LG washer. DO NOT attempt to stack this
dryer on any other washer, as damage,
injury or property damage could result.
Washer Top plate size
21.7 inch
(550mm)
Shape
and
assembly
direction
Installation Procedure
1. Place the LG dryer on the LG washing
machine.
2. Remove the two screws from the bottom
of the rear cover on each side as
illustrated below.
• Incorrect installation can cause serious
accidents.
• The weight of the dryer and the height
of installation makes the stacking
procedure too complex for one person.
This procedure should be performed by
2 or more experienced service
personnel.
• The dryer is not suitable for a built-in
installation. Please do not install as a
built-in appliance. Do not use or store
in any outdoor location.
• Do not operate if the dryer is
disassembled.
3. Align the stacking kit holes and the rear
cover holes.
3-1) 23.6 inch(600mm)
23.6 inch
(600mm)
3-2) 21.7 inch(550mm)
• Fasten the 2 screws that were removed
earlier from dryer to the stacking bracket.
• Use 4 screws supplied in the accessory
box [0.6inch(16mm)] to assemble the
staking bracket to the rear of the washer.
• The procedure for the opposite side will be
the same.
WARNING
7