Table of Contents
Advertisement
Location
4
5
6
1
7
Copier ADF Connector
6-4
Shipping material/Procedure
Installation of Original Catch Tray 1
(1) Install the original catch tray 1.
1
Check the gap between the ADF
and copier
(1) Remove the top left cover of the
copier. (2 screws)
(2) Check the gap between the ADF
and the copier. (Front and rear)
Adjust it if necessary. (Refer to
section 6.4)
Installation of Original Catch Tray 2
(FA-A350 only)
(1) Install the original catch tray 2
using the screws provided with
ADF.
Connection of lattice connector
(1) Connect the ADF lattice
connector to the copier ADF
connector.
(2) Turn on the power switch of the
copier.
(3) Place the original onto the ADF
and make a copy.
(4) Adjust the skew if necessary.
(Refer to section 6.4)
Check
Advertisement
Table of Contents
