Hamilton Beach TL-6-5A Instruction Manual page 9

5. Repeat last two steps until the dispenser is full.
6. Press the hot and cold spigots until the water just
begins to flow from the faucets.
7. Allow to sit for 15 – 20 minutes.
8. Rinse out the bleach solution by pouring
approximately 4 liters / 1 gallon of fresh tap
water into the top and drain by pressing
the hot and cold taps.
9. Flush with an additional 4 liters / 1 gallon of fresh
tap water and drain by pressing the hot
and cold spigots.
10. Install a fresh water bottle (see Preparing and
Loading Your Dispenser for Use).
11. Plug in the dispenser.
12. Dispense 1 liter / 1 quart of water from each spigot and make
sure the bleach solution has been completely removed.
13. If you continue to taste the chlorine from the bleach solution,
repeat steps 8 through 12 until the taste is gone.
To Remove Mineral Deposits
To remove mineral deposits, follow the instructions for Cleaning and
Sanitizing the Water Tanks, substituting either 2 liters / 2 quarts of water
mixed with 2 liters / 2 quarts of vinegar OR 4 liters / 1 gallon of water mixed
with 454 grams / 16 ounces of citric acid crystals. Bleach does not remove
mineral deposits.
8