Proper Installation And Location - Hamilton Beach TL-6-5A Instruction Manual

Proper Installation and Location

• This dispenser is for indoor use only. Do not use outdoors.
• Place the dispenser on a level surface that can support its weight with a
full water bottle installed.
• To ensure that your water dispenser works at the maximum efficiency,
leave at least 5 cm / 2 inches of clearance between all sides of the
dispenser and any walls.
• To avoid tipping hazard, the water cooler
may be attached to the wall using the
stability cable:
1. Attach the cable to the dispenser by
clipping the plastic end to the
condenser coils on the back of the unit.
2. Fasten the other end of the cable to
the wall using the screw provided as
shown in the diagram.
• To prevent damage to the dispenser, do not plug dispenser into the power
outlet until reading the instructions first!
Preparing, Loading and Operating
Your Dispenser
1. Make sure that the dispenser is not plugged into the electrical outlet.
2. The water bottle will have a cap. The cap may have a stopper that is
intended to be pushed into the bottle. (Sometimes these stoppers are
covered by a removable paper/foil seal.) If your bottle has a cap with
a stopper, simply hold the water bottle vertically straight upside down
and place the water bottle into the support collar on top of the water
dispenser. The post in the collar will push the stopper into the bottle.
For bottles that don't have a cap, quickly turn bottle vertically
and place into collar.
3. Plug the dispenser into the outlet.
5
Stability Cable