Related Manuals for Hamilton Beach 2202
Summary of Contents for Hamilton Beach 2202
-
Page 1: Water Dispenser
_________________________________ Water Dispenser Use & Care Manual Model 2202 Modelo 2202... -
Page 2: Important Safeguards
INTRODUCTION TO YOUR NEW HAMILTON BEACH WATER DISPENSER (model 2202) Congratulations, you have acquired a high quality Hamilton Beach Water Dispenser for bottled water. This unit is packed with many extra features that you will find convenient to use. Multi-temperature capability allows you to enjoy a cool drink, hot beverage or simply cook your meals. - Page 3 DANGER: CHILD ENTRAPMENT HAZARD. PROPERLY DISPOSE OF THE WATER DISPENSER AS DIRECTED BELOW. Child entrapment and suffocation are not problems of the past. Junked or abandoned REFRIGERANT DISPOSAL: dispensers with storage areas are still dangerous…even if they will sit for “just a Your old water dispenser may have used a few days.”...
-
Page 4: Proper Installation And Location
PROPER INSTALLATION AND LOCATION 1) Dispenser is for indoor use only. Do not use outdoors. 4) Place the dispenser on a level surface that can support its weight with a full 2) To prevent algae growth, find a water bottle on it. location for your dispenser that is protected from direct sunlight and 5) To ensure that your water dispenser... - Page 5 GETTING FAMILIAR WITH YOUR HAMILTON BEACH WATER DISPENSER Features: • Designed for in home or office use. • Front panel has three indicator lights, to see if the power, heating and cooling are on. • Two power switches are located on the back of the dispenser. One is for cooling and one for heating.
- Page 6 Parts Listing: Part No. Part Name Part No. Shown Part No. Part Name Part No. Shown on Diagram on Diagram HB-BS-1003 Bottle Supporter HB-DT-1012 Drip Tray HB-SE-1004 Separator HB-SD-1013 Storage Door HB-CT-1005 Cold Water Tank HB-RS-1014 Removable Shelf HB-GIL-1006 Green Indicator Light HB-HS-1015 Heating Switch HB-RIL-1007...
- Page 7 PREPARING, LOADING & OPERATING YOUR DISPENSER Make sure that the dispenser is not plugged into the electrical outlet and that both the hot and cold power switches (on the back of the dispenser) are set to the OFF position. Sanitize the dispenser water tanks prior to installing a full bottle of water for the first time (see “Proper Care and Cleaning of Dispenser”).
- Page 8 The hot water temperature is preset to 190 degrees Fahrenheit (88 degrees Celsius). The HOT dispenser button is equipped with a child safeguard that reduces the risk of hot water being dispensed accidentally or by small children. WARNING: BURN HAZARD. The dispenser heats water to a temperature of approximately 190 °...
- Page 9 IMPORTANT: Set both power switches (on the back of the dispenser) to the OFF position and unplug the water dispenser before cleaning. Use a solution of warm water and baking soda (approximately one tablespoon of baking soda to one quart of water). This will clean and neutralize odors. Then rinse and wipe dry. Other parts of the storage compartment including door gaskets and plastic parts can be cleaned in the same manner.
- Page 10 WARNING: BURN HAZARD. The dispenser heats water to a temperature of approximately 190 ° F(88 ° C). Water temperatures above 125 ° F (52 °C) can cause severe burns or death from scalding. Children, the disabled and the elderly are at highest risk of being scalded. Children should be supervised by an adult when using this product.
- Page 11 4) Remove the plastic separator by pulling straight out (you may need to twist slightly to loosen). 5) Clean the separator with dish soap and water or in the top rack of the dishwasher. 6) Dry the separator thoroughly on both sides. 7) Using a clean cloth or paper towel, thoroughly dry the cold water reservoir.
- Page 12 3) Reinstall the silicon stopper and drain cap (see Draining Instruction) 4) DO NOT ADD BLEACH FIRST OR DIRECTLY TO THE DISPENSER. Concentrated bleach may damage plastic. 5) Add ½ teaspoon (2.5 ml) of ordinary 6.0% maximum household bleach to a 2 quart (2 liter) pitcher filled with tap water.
-
Page 13: Trouble Shooting
To Remove Mineral Deposits: Mix 2 quarts (2 liters) of water with two quarts of vinegar OR mix 1 gallon of water (4 liters) with 16 ounces (454 g) of citric acid crystals. Bleach does not remove mineral deposits. Do this in place of step 6 above when removing mineral deposits. - Page 14 Temperature limiter tripped Set the hot and cold power switches to OFF position. Wait five minutes, then set switches to ON position. Wait 30 minutes for water to heat or cool. Water is not hot Dispenser is unplugged Push plug completely into outlet Heating switch not on Check to be sure heating...
- Page 15 Bottle making a gurgling noise this is normal Hot water boiling sound this is normal Dispenser or water bottle this is normal shakes when the cooling system cycles off Particles floating in Water has high mineral find a water source with Water content lower hardness...
- Page 16 Consumer Support__________________________________________________ Questions? How to contact us: Telephone 800-488-5080 (Monday – Friday 8:00AM-5:00 PM ET) E-mail: sales@hbwaterdispensers.com support@hbwaterdispensers.com...
-
Page 17: Limited 1-Year Warranty
LIMITED 1-YEAR WARRANTY What does this warranty cover? How do I make a warranty claim? - Any defect in materials or workmanship in the manufactured Return to the retailer from which it was purchased, along with a product copy of the store receipt within the given period of time allowed What does this warranty not cover? for returns by the retailer (i.e. -
Page 18: Quick Start Instructions
WELCOME TO ANOTHER DISPENSER, DO NOT PLUG IN OR TURN ENCIENDA SU DISPENSADOR DE AGUA ON YOUR WATER DISPENSER A NO SER QUE HAYA AGUA EN EL GREAT HAMILTON BEACH ™ UNLESS THERE IS WATER SISTEMA PRODUCT IN THE SYSTEM.